LG LSC23924ST - Manual (Page 18)

USING YOUR REFRIGERATOR
18
ICE PLUS
Press this button once to activate the ice plus function.
The ICE PLUS icon on the display panel will illuminate
when activated. The ice plus function runs the freezer
compartment at the coldest settings for a 24 hour period
to increase ice making. Press the button again to cancel
the Ice Plus function.
LOCK
The Lock button deactivates the temperature controls
and dispenser functions.
Press and hold this button for 3 seconds or until the
Lock indicator light is lit.
To disable the Lock function, press and hold the filter
button for 3 seconds or until the Lock indicator light is
off.
FILTER
(filter replacement cycle)
There is an indicator light for the water filter cartridge on
the dispenser that will blink to indicate it is time to change
the water filter. Water filters usually need to be replaced
once every six months. After replacing the filter, press and
hold the Filter Reset button for 3 seconds to turn off the
filter status light.
Display Off Mode
This display lights up and stays lit for 60 seconds when
the refrigerator is plugged in. Then all the display lights go
off except for the selected dispenser icon (water, or cubed
or crushed ice). In this Display Off mode, the display only
lights when the door is opened or the display button is
pressed.
To deactivate the Display Off Mode, press and hold the
Freezer Temp and Ice Plus buttons for 5 seconds until the
tone sounds. Repeat this procedure to reactivate the
Display Off Mode.
ADJUSTING CONTROL SETTINGS
RECOMMENDED
CONDITION/REASON:
ADJUSTMENT:
REFRIGERATOR section Adjust the
is too warm REFRIGERATOR
Opening the door often setting to the next
Adding a large amount of food highest number
Room temperature is very warm and wait 24 hours,
then check
FREEZER section is too warm/
ice is made too slowly
Opening the door often
Adding a large amount of food
Room temperature is very
low (not cycling often enough)
Using ice frequently
Air vents blocked by objects
Remove any
REFRIGERATOR section is too
cold
Controls not set correctly for
your conditions
FREEZER section is too cold
Controls not set correctly for
your conditions
Adjust the
FREEZER
setting to the next
highest number
and wait 24 hours,
then check
objects blocking
blocking air flow.
Adjust the
REFRIGERATOR
setting to the next
highest number
and wait 24 hours,
then check
Adjust the
FREEZER
setting to the next
highest number
and wait 24 hours,
then check
Give the refrigerator time to cool down completely
before making final adjustments. It is best to wait 24
hours before doing this. The initial settings mentioned in
CONTROL PANEL FEATURES section should be
correct for normal household refrigerator use. The
controls are set correctly when milk or juice is as cold as
you like and when ice cream is firm.
The refrigerator control functions as the thermostat for
the entire appliance (refrigerator and freezer sections).
The colder the setting,
compressor will the longer the
run to keep the temperature colder. The freezer control
adjusts the cold air flow from the freezer
to the
refrigerator. Setting the freezer control to a lower
temperature keeps more cold air in the freezer
compartment to make it colder.
If you need to adjust temperatures in the refrigerator or
freezer, start by adjusting the refrigerator and allow 24
hours for the temperature to stabilize. If it is too warm or
too cold, then adjust the freezer control.
Use the settings listed in the chart below as a guide.
Always remember to wait at least 24 hours between
adjustments.