Techne PrimeQ - Manual (Page 110)

110
3.10.1.1 General points
• Analysis methods can be added or changed post-run as long as the assay setup is valid for
the method (see above table).
• If multiple dyes are to be corrected differently within a stage then this must be performed
post-run.
• Data can be re-analysed an unlimited number of times – simply ensure any graphs or
calculations of interest have been saved and change any analysis parameters or methods
via the Analysis Selection box in the Results Editor. This works in the same way as when
setting up parameters in the Experiment Editor. If running multiple stages with read points,
data will be tabbed according to the experiment and the stage name.