APC AP9312TH - Manual (Page 18)

Environmental Monitoring Unit: User’s Guide 14
Menu Items
Network continued
SNMP The SNMP section displays the SNMP access control and trap receiver
Settings.
Access Control . The Access Control section of SNMP displays the
current settings for all four SNMP channels and lets you configure
values for a selected channel.
Trap Receiver. The Trap Receiver section of SNMP displays and lets
you configure the current settings for all four trap receivers.
Continued on next page
Item Item Item Item Definition Definition Definition Definition
SNMP Access Enables or disables SNMP access.
Access Control Controls access to each of the four SNMP channels.
Trap Receiver Defines the NMSs (up to 4) to which traps are sent.
Item Item Item Item Definition Definition Definition Definition
Community
Name Password that the NMS specified by the NMS IP option must use
for SNMP access to the unit. The Access Type option defines
the allowed access.
Note: Allows a maximum of 15 characters.
NMS IP Configures the channel to allow only one NMS (using a specific
NMS IP address), or all NMS s (using 0.0.0.0 for the NMS IP
value), to have access to the channel.
Access Type Defines whether the NMS identified by the NMS IP option can
write (use GET s and SET s) or read (use only GET s) or is disabled
(cannot use GET s or SET s ).
Item Item Item Item Definition Definition Definition Definition
Community Name The password that the unit uses when it sends traps to the
NMS identified by the
Receiver NMS IP option.
Maximum length: 15 characters.
Receiver NMS IP The specific NMS (defined by its IP address) to receive traps
sent by the unit.
Note: To send no traps to any NMS , set the Trap Receiver
IP to 0.0.0.0
Trap Generation Enables or disables the sending of traps to the NMS
identified by the Receiver NMS IP option.
Authentication Traps Enables or disables the sending of authentication traps to
the
NMS identified by the Receiver NMS IP option .