Burcam 300527 SUBM SUMP PUMP S. STEEL 3/4HP 115V WITH 20FT CABLE - Manual (Page 2)

SAFETY INSTRUCTIONS:
This fine pump that you have just purchased is designed from the latest in material and
workmanship.
Before installation and operation, we recommend the following procedures:
CHECK WITH YOUR LOCAL ELECTRICAL AND PLUMBING CODES TO ENSURE YOU
COMPLY WITH THE REGULATIONS. THESE CODES HAVE BEEN DESIGNED WITH
YOUR SAFETY IN MIND. BE SURE YOU COMPLY WITH THEM.
WE RECOMMEND THAT A SEPARATE CIRCUIT BE LEAD FROM THE HOME ELECTRI-
CAL DISTRIBUTION PANEL PROPERLY PROTECTED WITH A FUSE OR A CIRCUIT
BREAKER. WE ALSO RECOMMEND THAT A GROUND FAULT CIRCUIT BE USED.
CONSULT A LICENSED ELECTRICIAN FOR ALL WIRING.
THE GROUND TERMINAL ON THE THREE PRONG PLUGS SHOULD NEVER BE
REMOVED. THEY ARE SUPPLIED AND DESIGNED FOR YOUR PROTECTION.
NEVER MAKE ADJUSTMENTS TO ANY ELECTRICAL APPLIANCE OR PRODUCT WITH
THE POWER CONNECTED. DO NOT ONLY UNSCREW THE FUSE OR TRIP THE
BREAKER, REMOVE THE POWER PLUG FROM THE RECEPTACLE.
YOUR SUMP PIT MUST BE CONSTRUCTED FROM CONCRETE, BRICK, TILE OR MORE
RECENTLY A SUMP BASIN MADE FROM PLASTIC AND/OR FIBERGLASS. THE MINIMUM
SIZE OF YOUR SUMP PIT MUST BE 18” IN DIAMETER AND NO LESS THAN 25” DEEP
Material required for submersible sump pump application
Submersible sump pump installation
 Desired length of 1 1/2” or 1 1/4” of ABS/DWV pipe to link up the pump to the drain line.
 1 only 1 1/4” check valve (350353) (Note that this 1 1/4” check valve may also be use
with a 1 1/2” pipe).
 18” x 25” sump basin.
 1 1/4”-1 1/2” stainless steel clamps (750886).
ABS cement.
2
Tools
Screwdrivers, hacksaw to cut pipe, knife to assist in pipe cutting, round file to smooth pipe
ends, pipe wrench, adjustable wrench to tighten fittings.
NOTICE
This unit is not designed for applications
involving salt water or brine .
Use with salt water or brine will void
warranty.
A
B
C
D
E