Brocade 300 installation and configuration, Items included with the brocade 300, Installation and safety considerations – Brocade 300 Hardware Reference Manual User Manual
Page 15: Installation precautions
Brocade 300 Installation and Configuration
Items included with the Brocade 300
The following items are included with the standard shipment of the Brocade 300. When you open the
Brocade 300 packaging, verify that these items are included in the package and that no damage has
occurred during shipping:
• One Brocade 300 Fibre Channel switch
• An accessory kit containing:
‐
Serial cable with an RJ-45 connector
‐
6 ft. Power Cord
‐
Rubber feet, required for setting up the switch as a standalone unit
‐
Brocade Family Documentation CD
‐
Brocade 300 QuickStart Guide
‐
EZSwitch Setup CD
‐
Access Gateway Quick Start Guide
Installation and safety considerations
You can install the Brocade 300 switch in the following ways:
1. As a standalone unit on a flat surface.
2. In an EIA rack using a fixed-rail rack mount kit. The optional fixed-rail rack mount kit can be ordered
from your switch retailer.
3. In an EIA rack sing an optional slide-rail rack mount kit. The optional slide-rail rack mount kit can be
ordered from your switch retailer.
Installation precautions
When using this product, observe all danger, caution, and attention notices in this manual. The notices
are accompanied by symbols that represent the severity of the safety condition.
NOTE
Refer to
on page 45 for translations of safety notices for this product.
Brocade 300 Hardware Reference Manual
15
53-1000862-06