Ultra Start 670 Series - Manual (Page 6)

OWNER’S MANUAL
PAGE 6
Temporary Shock Sensor Bypass.
Within three seconds press and release the button and then press and
release the button. The system will chirp once when the button is pressed
and once when the button is pressed. The shock sensor will be disabled until
the system is disarmed and the rearmed again.
Shock Sensor Programming/ Adjustment
Adjusting the shock sensor:
While the park lights are “ON”, strike the vehicle with the amount of force
wanted to trigger the alarm.
NOTE: The siren will chirp 3 times each time the system detects impact.
Press and release to increase sensitivity (up to 10 chirps/ flashes).
Press and release to decrease sensitivity (down to 1 chirp/ flash).
NOTE: Be careful not to impact the vehicle in a area that may cause damage.
The most common location for testing and setting the shock sensor is
the vehicles A-pillar. The A-Pillar is the metal support that runs from the
roof of the vehicle to the hood area.
To enter shock sensor programming:
Press and hold and buttons for three seconds.
The park lights will flash and the siren will three times.
To exit and save shock sensor programming:
Press and hold and , the siren will chirp and the park lights will flashh the
number of times of the shock sensor impact level chosen.
Example: Level 5 = 5 Chirps/ 5 Park Light flashes
Shock Sensor Programming/ Adjustment