Northstar Trailers SPORTSTAR III - Manual (Page 9)

a. Fasten the taillight/brake light L-brackets (Q) to the frame using two, 3” bolts
(X), one small flat-washer (K) and one small locknut (V) for each bolt.
b. Remove the nuts from the back of the taillight (O).
c. Determine the length of the wires needed to connect the wiring harness with
the light, then twist the wires together to shorten the wire slack.
d. Place the loop from the harness’s white ground wire over the closest stud on
the back of the light.
e. Connect the taillight wires with like colors from the wiring harness.
f. Slide the studs on the back of the taillight (O) through the L-bracket.
g. Slide the license plate bracket (R) onto the taillight studs.
h. Use the nuts from the back of the taillight to fasten the light to the bracket.
i. Shove any excess wire back into the eyehole of the frame.
Note: follow the same sequence for the passenger-side taillight, but without the license
plate bracket.
INSTALL RUNNING LIGHTS
a. The white wire from the harness is not needed for ground on this light and
can be capped off (with wiring connector (U)) or tied to other wires in the
harness with a small zip-tie.
b. Connect the brown wire from the running light (P) with the brown wire from
the wiring harness by pushing the wires together.
c. Position the brown wire under the silver tab, between the tab and the lens.
Run the screw through the silver tab, and then fasten the light to the trailer
using two small brass screws (T), found in the small bag with the wire
connectors.