0 troubleshooting – LEESON SM-Basic Series Sub-Micro Inverters (Obsolete) User Manual
Page 41

37
Press
Mode to view parameter contents
(77 = 77% LOAD)
Press
Mode again to exit
Upper right decimal point blinks
Press
Mode once
Upper right decimal point blinks
Display reads "00"
Press
Mode again
Display reads "50" (FAULT HISTORY)
Use
s and t to scroll to the desired
parameter number
(In this example Parameter 54 has been
selected, which is MOTOR LOAD)
16.0
TROUBLESHOOTING
To aid in troubleshooting, Parameters 50 through 58 can be accessed without entering the PASSWORD.
Simply press the
Mode button twice to “skip” over the PASSWORD prompt, and “50” will be
displayed to indicate that the parameter menu has been entered and Parameter 50 (FAULT HISTORY)
can be viewed. The
s and t buttons can then be used to scroll from Parameter 50 to Parameter 58.
Once the desired parameter is found, press the
Mode button to view its “contents”. When finished,
press
Mode to exit the parameter menu. An example is shown below:
In the example above, Parameter 54 - MOTOR LOAD is being viewed. The “77” in the example
indicates that the load on the motor is 77% of the output current rating of the drive.