King Kooker 2106 Heavy Duty Portable Propane Outdoor Smoker Package - Manual (Page 10)

10
5. Install the burner shroud with steel burner onto the bottom of the smoker using three black bolts as
pictured in Figure 3. Make sure the end of the venturi tube of the burner is placed securely over the
end of the valve extending from the backside of the face panel before tightening shroud to base of
smoker. Connect the piezo line (line with white plastic covering) to the red ignitor button’s black
plastic body on the back side of the face panel. Test the connection by pushing the red ignitor button
on the face panel. You should see a spark between the end of the exposed piezo wire and burner. If
not sparking, check connections and make sure wire is not touching burner. There should be a
distance of 3/16” (4.8mm) between the end of the electrode tip and the burner for proper operation.
6. Install adjustable stack on top of smoker using four black bolts. The adjustable stack vent
should be directed towards the back of the smoker (See Figure 1, page 8).
7. Install cool grip side handles on both sides of smoker using four black bolts (2 on each
handle). Bolts should thread towards inside of smoker (See Figure 1, page 8).
8. Install the two side dampers onto smoker cabinet using two black bolts (one bolt on each damper).
Bolts should thread toward inside of smoker (See Figure 1, page 8).
9. Install front smoker door handle using one cool grip door handle, front door latch (big
bend) and nut. Insert handle through front smoker door as shown in Figure 4. Keep cool grip
handle horizontal. Place front door latch (big bend) over threaded end of handle on back side
of front smoker door. The bend on latch should be pointed down (See Figure 5 below).
Tighten with supplied nut. To latch the door shut, close door and turn handle down to latch in place.
Control Knob
Piezo Ignitor Button
Figure 7
Venturi
Tube
Figure 3
Figure 4 Figure 5
Piezo
Line
Valve
Valve
Venturi Tube
Piezo
Line