Bosch TDS2011 - Manual (Page 17)

17
B O S C H
EN
G
LI
SH
2. Place your appliance on the edge of your kitchen
sink.
3. Remove the plastic cover located on the bottom of
the appliance by turning it to the position.
4. Unscrew the boiler drainage plug using a coin.
5. Holding your steam generator in upside down
position, and using a jug, ill the boiler (in the base
unit) with 1/4 litre of water
6. Shake the base unit for a few moments and then
empty it completely over a sink or bucket. To
obtain the best result, we recommend that this
operation is done twice.
Important: before re-closing, make sure no water
remains in the boiler.
7. Replace and tighten up the boiler drainage plug
with a coin.
8. Insert and close the plastic cover by turning it to
the position.
G
Rinsing the iron steam
chamber
Caution! Risk of burns!
This procedure helps to remove scale particles out
of the steam chamber.
This cleaning procedure may be performed
occasionally (approximately once a year), when
after a long period of use with very hard water, scale
particles start to come out of the soleplate.
a) Ensure that the iron is cooled down.
b) Set the temperature selector (13) of the iron to the
“min” position.
c) Fill the tank with tap water.
d) Plug in the mains cable and set the main power
switch (11) to the “I” position.
e) Wait until the “steam ready” indicator lamp (8)
lights up.
f) Hold the iron over the sink or a container to collect
the water.
g) Press the steam release button (14) and gently
shake the iron. Boiling water and steam will come
out, carrying scale and or deposits that might be
there. This could take approximately 5 minutes.
h) Set the temperature selector (13) of the iron to the
“max” position, without pressing the steam release
button (14). The water in the steam chamber will
start evaporating. Wait until all the water inside the
chamber has been evaporated.
i) To clean the soleplate, immediately rub off any
residue by running the hot iron over dry cotton
cloth.
Advice on disposal
Our goods come in optimised packaging. This
basically consists in using non-contaminating
materials which should be handed over to the local
waste disposal service as secondary raw materials.
Your local town council can give you information
about how to dispose of obsolete appliances.
This appliance is labelled in
accordance with European Directive
2002/96/EG concerning used
electrical and electronic appliances
(waste electrical and electronic
equipment - WEEE).
The guideline determines the
framework for the return and
recycling of used appliances as applicable
throughout the EU.
Trouble shooting
Problem Possible causes Solution
The steam generator
does not come on.
• There is a connection problem.
• The main power switch is not
switched on.
• Check the mains cable, the plug and the
socket.
• Set the main power switch (11) to the “I”
position.
The iron does not
heat up.
• The main power switch is not
switched on.
• The temperature control knob is set
to the “min” position.
• Set the main power switch (11) to the “I”
position.
• Set the temperature selector (13) to the
desired position.