Aiwa NSX-AJ14 - Manual (Page 14)

14
ENGLISH
PROGRAMMED EDIT RECORDING
In the programmed edit recording function the tracks can be
programmed while checking the remaining time on each side of
the tape.
1 Insert the tape into deck 1, and wind up to the
beginning of the front side.
Press Z to open the cassette holder and insert the tape
with the side to be recorded on first facing out from the unit.
Wind up the tape with
f .
2 Press CD and load the disc(s).
3 Press CD EDIT/CHECK twice while pressing
SHIFT on the remote control.
“EDIT” and “PRGM” are displayed.
• When “AI” is displayed, press CD EDIT/CHECK while
pressing SHIFT again.
4 Press numbered buttons 0-9 on the remote
control to designate the tape length.
10 to 99 minutes can be specified.
•
f and g are also available to designate the tape length.
5 Press DISC DIRECT PLAY 1-3 to select a disc.
Then, press numbered buttons 0-9 and + 10 on
the remote control to program a track.
Example: To select the 10th track of disc 2, press DISC
DIRECT PLAY 2, then press +10 and 0.
6 Repeat step 5 for the rest of the tracks for side
A.
A track whose playing time is longer than the remaining time
cannot be programmed.
7 Press CD EDIT/CHECK while pressing SHIFT on
the remote control to select side B and program
the tracks for side B.
After confirming “B” on the display, repeat step 5.
8 Press CD EDIT/CHECK while pressing SHIFT on
the remote control to select side A and press w
to start recording.
CD play and recording of edited tracks for the first side start
simultaneously. When the end of tape is reached, deck 1
enters the recording stop mode. After entering the recording
stop mode, go to step 9.
9 Press CD EDIT/CHECK while pressing SHIFT on
the remote control for recording of the second
side.
“B” is displayed.
10 Turn over the tape in deck 1 and press w to start
recording.
Recording starts.
To stop recording
Press Z on deck 1. Recording and CD play stop
simultaneously.
To check the order of the programmed track numbers
Before recording, press CD EDIT/CHECK while pressing SHIFT
on the remote control to select side A or B, and press
f or
g repeatedly.
To change the program of each side
Press CD EDIT/CHECK while pressing SHIFT on the remote
control to select side A or B, and press
s CLEAR to clear the
program on the selected side. Then program tracks again.
To clear the edit program
Press s CLEAR twice so that “EDIT” disappears on the display.
• Up to 30 tracks can be programmed from any of the inserted
discs.
• “FULL” is displayed if you attempt to program more than 30
tracks.
Maximum recording
time for side A
Tape side A (front side)
Tape length
Remaining time on side A
Programmed tracks
Program number
Selected track number
Tape side B (reverse side)
Program number
Programmed
track numbers
Tape side
Track number Disc number