Poulan Pro Pro 900 ZX 968999302 - Manual (Page 46)

English-
44
MAINTENANCE
EZT belt
To replace EZT (E-Series Zeroturn
Transaxle) belt
Park the mower on a level surface. Engage
the parking brake.
EZT belt removal
NOTE: Be careful not to damage the fan
blades on the EZT´s as this can affect cooling
or damage the EZT´s
• Remove the deck belt (see to replace
deck belt in this section of the manual).
• Unplug clutch from wiring harness.
Remove bolt from center of clutch and
slide clutch off of engine shaft.
• Create slack in the belt by removing the
spring on the pump idler arm.
• The belt should now be able to be
removed from the engine pulley and
EZT
pulleys.
Belt installation
• Wrap the EZT belt around the EZT
pulleys
• Route the belt around the inside of the
idler pulley.
• Now you can wrap the belt around the
engine pulley.
• Reattach the spring on the pump idler
arm.
• Install clutch on to engine shaft (pulley
side down) make sure key is installed
and align the clutch anti rotation tab into
slot on clutch. Secure clutch, install wire.
• Reinstall the deck belt onto the electric
clutch belt (see to replace deck belt in
this section of the manual).
Transaxle belt
CZ-21