Bosch Kompakt-Dampfgenerator Sensixx´x DI90 AntiShine TDI902836A magic night blue weiß - Manual (Page 17)

17
BOSCH
ENG
lISH
11. Water tank
12. Level mark for maximum filling
13. Soleplate
14. Temperature index
15. Temperature control with “TempOK” indicator
16. “Calc’nClean” button
17. “Pump on” indicator lamps
18. Power cable
19. Descaling fluid*
20. “TextileProtect” soleplate cover*
21. “StoreProtect” accessory*
* model dependent
Description
1. Handle with contact sensor
2. Steam activation button*
3. “SensorSteam” indicator lamp (clear light)
4. Steam setting selection button (SET)
5. Steam setting indicator lamps
green = eco
red = max
6. Shot of steam button
7. Spray button
8. Water inlet
9. Water inlet lid
10. Spray nozzle
Important notices :
• This appliance reaches high temperatures and
produces steam during use, this could cause
scalds or burns in case of improper use.
- Do not touch the soleplate! Hold the iron by
its handle.
- Do not leave the supply cord hanging over
the table or ironing board, to prevent the
appliance from falling.
- Do not iron clothing while it is being worn!
- Never spray or aim the steam at persons or
animals!
• Do not allow the power cable to come into
contact with sharp edges or with the soleplate
when it is hot.
• Never rest the iron in a horizontal position
when the soleplate is hot. Rest it on its heel.
• Do not touch the appliance with wet hands
when in operation.
• This appliance is to be connected and used in
accordance with the information stated on its
characteristics plate.
• This appliance must be connected to an
earthed socket. If it is absolutely necessary
to use an extension cable, make sure that it
is suitable for 16A and has a socket with an
earth connection.
• If the safety fuse fitted in the appliance blows,
the appliance will be rendered inoperative. To
restore normal operation the appliance will
have to be taken to an authorised Technical
Service Centre.
• In order to avoid that, under unfavourable
mains conditions, phenomena like transient
voltage drops or lighting fluctuations can
happen, it is recommended that the iron is
connected to a power supply system with a
maximum impedance of 0.27Ω. If necessary,
the user can ask the public power supply
company for the system impedance at the
interface point.
• In special environmental conditions slight
instability may occur.
• The appliance must never be placed directly
under the tap to fill the water tank.
• Unplug the appliance from the mains supply
after each use, or if a fault is suspected.
• The electrical plug must not be removed from
the socket by pulling the cable.
• Never immerse the iron in water or any other
fluid.
• Do not leave the appliance exposed to
weather conditions (rain, sun, frost, etc.)
• While the steam is being released, the iron
produces a pumping sound. This is normal,
indicating that water is being pumped to the
steam chamber.