Detroit Radiant Products Company HLV Series - Manual (Page 30)

30
HLV Series 3.0 Installation • Burner Assembly and Mounting
1 Determine the mounting chain locations for hanging the burner control box.
2 Fasten beam clamp, screw hook or other type of suspension anchor to hanging point.
3 Attach S-Hook and #1 double loop chain (P/N: THCS) to anchor. Check that it is securely
connected.
4 Attach chain assemblies and S-Hooks to mounting brackets on the burner control box. Adjust chain
lengths until level and in straight alignment with radiant tubes (Figure 3.16).
Figure 3.16 • Burner Control Box Assembly • Side View
Burner Sight Glass
(bottom side of the tube)
Burner tube is in straight
alignment with 10 ft. Primary
Combustion Chamber
Figure 3.17 • Burner Control Box • End View
12”
16”
18”
5.5” 5”
3.5”
3”
8.1”
8.1”
Burner box
mounting
bracket
Burner Assembly and Mounting
WARNING
!
Conditions such as wind drafts or other variables can cause movement of the heater and
may require it to be rigidly mounted. Avoid excessive movement and/or vibration of the
gas connection by rigidly mounting the burner control box. All remaining hanging points
should use chains to allow for expansion.
The heater must be independently supported and in no case shall the gas or electrical supply support
the weight of the heater.