Detroit Radiant Products Company HLV Series - Manual (Page 3)

Overview
The intent of this manual is to provide information regarding general safety, installation, operation and
maintenance of the tube heater vacuum system. You must read, and understand, the instructions and
safety warnings in this manual before installing the heating system.
System Components*
Prior to installation, verify that the heater’s gas type and voltage (as listed on the rating plate) match that of
your application. Also verify that you have received all heater contents included with your system by
checking them against the packing list. Materials not included in the heater kit contents (e.g., screws, vent
material, terminals, etc.) are the responsibility of the installer. Notify your product representative or Detroit
Radiant Products of any discrepancy or missing kit contents prior to installing unit.
1.0 Introduction
Figure 1.1 • Typical System Components*
* Each HLV Series vacuum system
is engineered specific to each
application’s design parameters.
Some items illustrated may not be
required with your system.
Tube Hanger
Standard
Reflector
Reflector Center
Support
Primary/Secondary
Combustion Chamber(s)
Baffles
Reflector End
Cap w/Clips
Tube Clamp
Burner Control Box
SS Flex Connector
Shut-off Valve
Radiant
Tube(s)
Ignitor/
Sensor Box
Chain Set
16” Burner Tube
Reflector
Tension Spring
Isolation Boot
Turnbuckle .
Vacuum Pump
Damper
3
HLV Series
1.0 Introduction • Overview • System Components
Refer to pages 50-51 for a complete parts breakdown.