Detroit Radiant Products Company HLV Series - Manual (Page 26)

26
HLV Series 3.0 Installation • Tube Assembly and Mounting • Turnbuckle Suspension
After the first tube run is completely installed (all tubes, clamps, dampers, elbows, intersections,
etc.), continue the installation with the run having the next greatest amount of run or condensing
pipe. Continue until all runs are complete - ensure all dampers are properly placed.
NOTE: For ease of installation, install reflectors as each tube section is installed. Refer to page 28
for reflector assembly instructions.
1 Temporarily set each damper to half-closed.
2 Adjust suspension hardware so tubes are aligned straight. Adjust chain lengths until standard
radiant tube is level and, if applicable, the condensing pipe is at the proper pitch (1/4in:10ft).
Turnbuckles (P/N: V-TB) are recommended for ease of sloping condensing pipe (Figure 3.11).
Figure 3.11 • Turnbuckle Suspension Details
Beam Clamp
Turnbuckle
Double-Loop
Chain
Threaded
Rod
S-Hook
Bar Joist Clip
Wood Beam
Anchor Lock Nut
Washers