Detroit Radiant Products Company QTS Series - Manual (Page 3)

1.0 Introduction
QTS Series
3
Overview
The intent of this manual is to provide information regarding general safety, installation, operation and
maintenance of this radiant tube heater. You must read and understand all instructions and safety
warnings before installing or servicing the radiant tube heater.
Heater Components
Prior to installation, verify that the heater’s gas type and voltage (as listed on the rating plate) match
that of your application. Also verify that you have received all heater components included with your
radiant tube heater. Refer to page 44 for a list of the kit contents for your Series heater. Materials not
included in the heater kit contents (e.g., screws, vent material, terminals, etc.) are the responsibility of
the installer. Notify your product representative or Detroit Radiant Products of any discrepancy or
missing kit contents prior to installing unit.
Specifications
Chart 1.1 • QTS Series Specifications
* Input at full rate.
** Typical or recommended mounting heights are provided as a guideline. Actual conditions may dictate
variations from this data.
Shipping / Boxing:
B = Burner Control Box (45#) & (31.5”L x 17.5”W x 15.5”H).
T = Emitter Assembly and Reflector Box (88#) & (91”L x 31”W x 14”H).
NOTE: See Kit Contents on page 44.
1.0 Introduction • Overview • Heater Components • Specifications
Model Number Gas Type BTU/h *
Typical or Recommended
Mounting Heights** Unit Weight
Overall Unit
Length
QTS-60N Natural Gas 60,000 8 to 12 ft. 103 lbs. 103”
QTS-60P Propane 60,000 8 to 12 ft. 103 lbs. 103”
QTS-80N Natural Gas 80,000 10 to 14 ft. 103 lbs. 103”
QTS-80P Propane 80,000 10 to 14 ft. 103 lbs. 103”