Chamberlain TAC1 - Manual (Page 17)

17
NOTE: Use the STAR Key “*” to cancel any input.
NOTE: Keypad commands are to be entered in a single string to result in success (indicated by double high tone). Stop and go
keystrokes will result in negative tones (low single and triple fail tones).
AUDIO FEEDBACK FROM THE TAC1:
1 Low Tone Beep = Failure
2 Two High Tone Beeps = Valid sequence
3 Low Tone Beep = Error or invalid sequence
PROGRAMMING
>> QUICK REFERENCE
KEYPAD PROGRAMMING
PROGRAMMING
NUMBER
DESCRIPTION OF TASK FACTORY
SETTING
PROGRAMMING PROCEDURE
1 Trigger Relay One and Radio
Channel One Master Code (4 digits) + 1
2 Trigger Relay Two and Radio
Channel Two Master Code (4 digits) + 2
7 Delete User Code Master Code (4 digits) + 7 + User Code that is to be deleted
(4 digits)
9 Enter User Code Master Code (4 digits) + 9 + New User Code (4 digits) +
Relay/Channel Associated with the User Code (1 or 2)
03 Enable Intercom (No-Telco)
Mode Master Code (4 digits) + 03
04 Enable Telco Mode Enabled Master Code (4 digits) + 04
06 Speaker Volume Level 2 Master Code (4 digits) + 06 + Volume Level
(1 = Low, 2 = Medium or 3 = High)
07 Microphone Sensitivity Level 2 Master Code (4 digits) + 07 + Volume Level
(1 = Low, 2 = Medium or 3 = High)
09 Change the Master Code Master Code (4 digits) + 09 + ### + New Master Code (4 digits)
51 Create Temporary (1 Shot)
Code Master Code (4 digits) + 51 + New Temporary (1 Shot) Code
(4 digits) + Relay Associated with the User Code (1 or 2)
(Expires after 24 hours.)
52 Enable Vacation (Lock Down)
Mode Disabled Master Code (4 digits) + 52
53 Disable Vacation (Lock Down)
Mode Master Code (4 digits) + 53
54 Engage Party Mode (Relay 1) Disabled Master Code (4 digits) + 54
56 Engage Party Mode (Relay 2) Disabled Master Code (4 digits) + 56
021 Enable Parallel Relay Output Enabled Master Code (4 digits) + 021
023 Enable Independent Relay
Output Control Disabled Master Code (4 digits) + 023
024 Adjust Relay Output Time
(Relay 1) .5 seconds Master Code (4 digits) + 024 + Relay Output Time (0000-8000
seconds) NOTE: Relay output time is ALWAYS 4 digits.
025 Adjust Relay Output Time
(Relay 2) .5 seconds Master Code (4 digits) + 025 + Relay Output Time (0000-8000
seconds) NOTE: Relay output time is ALWAYS 4 digits.
DIRECT COMMANDS FROM THE TAC1 KEYPAD
KEYSTROKES ACTION
User Code + 1 Triggers Relay 1
User Code + 2 Triggers Relay 2