Code setup, Code operation, Master code operations – Chamberlain TAC1 User Manual
Page 14: User code operations, Programming, Code setup and code operation, Code setup code operation
14
The unit’s Master Code is for owner/administrator level commands. The User Codes allow users to activate and
latch relays 1 and 2 and to transmit radio commands on channels one and two.
NOTE: The User Code cannot be the same as the Master Code.
PROGRAMMING
>> CODE SETUP AND CODE OPERATION
TRIGGER RELAY 1 (ONLY)
Enter the Master Code:
?
?
?
?
NOTE: Requires Relay 2 be in Independent Mode.
ENABLE VACATION (LOCK DOWN) MODE
Locks the system from all User Code activity.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
5
2
DISABLE VACATION (LOCK DOWN) MODE
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
5
3
TRIGGER RELAY 1 AND CHANNEL 1
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
1
TRIGGER RELAY 2 AND CHANNEL 2
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
2
CODE SETUP
CODE OPERATION
MASTER CODE OPERATIONS
TRIGGER PROGRAMMED RELAY/CHANNEL FOR USER CODE
Enter the User Code:
?
?
?
?
The appropriate
Relay/Channel will activate.
USER CODE OPERATIONS
ENTER A TEMPORARY (1 SHOT) USER CODE NUMBER
The TAC1 holds 1 temporary User Code.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
5
1
The unit will beep.
3. Enter the Temporary User Code:
4. Enter the Relay for the Code to control:
1
or
2
or no
button is pressed.
NOTE: If no button is pressed in step 4, both relays will
activate simultaneously. Expires in 24 hours or after
fi rst use.
ENGAGE PARTY MODE (RELAY 1)
Party Mode will latch relay and trigger corresponding
channel.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
5
4
To disengage party mode: Enter a valid code into the TAC1
keypad or enter “*9” into the local telephone.
ENGAGE PARTY MODE (RELAY 2)
Party Mode will latch relay and trigger corresponding
channel.
1. Enter the Master Code:
?
?
?
?
2. Enter the Program Code:
5
6
To disengage party mode: Enter a valid code into the TAC1
keypad or enter “*5” into the local telephone.
NOTE: Relay 2 must be in Independent Control Mode to
engage Party Mode on relay 2. See page 13.
ENTER A USER CODE NUMBERS
1. Enter the Master Code:
?
?
?
?
The unit will
beep.
2. Enter the Program Code:
9
The unit will beep.
3. Enter New User Code:
4. Enter the Relay/Channel for the Code to control:
1
or
2
or no button is pressed.
NOTE: If no button is pressed in step 4, both
relays/channels will activate simultaneously, when in
parallel mode.
DELETE USER CODE NUMBERS
1. Enter the Master Code:
?
?
?
?
The unit will
beep.
2. Enter the Program Code:
7
The unit will beep.
3. Enter User Code to be deleted:
8
9
7
0
2
3
1
5
6
4