Clear-Com PTX-3 - Manual (Page 27)

Vitec Group Communications
PTX-3 UHF Digital Hybrid IFB Transmitter 2 - 3
Indicators:
Backlit Liquid Crystal Display. Displays
modulation meter, frequencies, modes,
rolloff, audio level, and tuning groups
Front Panel Controls:
MENU momentary pushbutton switch
Power OFF-TUNE-XMIT, 3 position
slide switch
Select Up momentary pushbutton switch
Select Down momentary pushbutton
switch
Rear Panel Controls:
Input Mode Select, 4 section DIP switch
Weight:
9oz
Size:
5.25” long (including connectors) x 3.25”
wide x 1.25” high
Emission designator:
180KF3E
The T4 IFB transmitter is FCC type accepted under Part 74:470 -
608MHz and 944.1 - 951.9 MHz
The FCC requires that the following statement be included in this
manual:
This device complies with FCC radiation exposure limits as set forth for
an uncontrolled environment. This device should be installed and
operated so that its antenna(s) are not co-located or operating in
conjunction with any other antenna or transmitter. A separation
distance of at least 20cm (8 inches) must be maintained to comply with
the FCC Radio Frequency Maximum Permissible Exposure (MPE)
requirements.
Notice About Specifications
While Clear-Com makes every attempt to maintain the accuracy of the
information contained in its product manuals, that information is subject to
change without notice. Performance specifications included in this manual are
design-center specifications and are included for customer guidance and to
facilitate system installation. Actual operating performance may vary.