beautypg.com

Diagnostic programming mode – Hydrotech SXT Timer User Manual

Page 9

background image

DIAGNOSTIC PROGRAMMING MODE

Diagnostic Programming Mode Options

Abbreviation

Parameter

Description

FR

Flow Rate

Displays the current outlet flow rate

PF

Peak Flow

Rate

Displays the highest flow

rate measured since the last

regeneration

HR

Hours in

Service

Displays the total hours that the unit

has been in service

VU

Volume Used

Displays the total volume of water

treated by the unit

RC

Reserve

Capacity

Displays the system’s reserve

capacity calculated from the system

capacity, feedwater hardness, and

safety factor

SV

Software

Version

Displays the software version

installed on the controller

NOTE: Some items may not be shown depending on timer

configuration. The timer will exit Diagnostic Mode

after 60 seconds if no buttons are pressed. Press

the Extra Cycle button to exit Diagnostic Mode at

any time.

Diagnostic Programming Mode Steps
1. Press the Up and Extra Cycle buttons for five seconds

while in service.

2. Use this display to view the current Flow Rate. This option

setting is identified by “FR” in the upper left hand corner of

the screen.

3. Press the Up button. Use this display to view the Peak Flow

Rate since the last regeneration cycle. This option setting

is identified by “PF” in the upper left hand corner of the

screen.

4. Press the Up button. Use this display to view the Hours

in Service since the last regeneration cycle. This option

setting is identified by “HR” in the upper left hand corner of

the screen.

5. Press the Up button. Use this display to view the Volume

Used since the last regeneration cycle. This option setting

is identified by “VU” in the upper left hand corner of the

screen.

6. Press the Up button. Use this display to view the Reserve

Capacity. This option setting is identified by “RC” in the

upper left hand corner of the screen.

7. Press the Up button. Use this display to view the Software

Version. This option setting is identified by “SV” in the upper

left hand corner of the screen.

8. Press the Extra Cycle button to end Diagnostic

Programming Mode.

Fleck SXT Timer JL10 • 9