Draw-Tite 118404 T-ONE CONNECTOR User Manual
Draw-Tite For the car

CA
UTION
V
erify what is behind any surface prior
to drilling to avoid damage to the vehicle
and/or personal injury. Do not drill into
any exposed surfaces.
W
ARNING
All connections m
ust be complete for the
T-Connector to function properly. Test and
verify installation with a test light or trailer
once installed.
5. Replace car
pet, wing nuts and any other
clips or panels that were removed during
installation being careful not to cut or pinch
the wires.
W
ARNING
Ov
erloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. stop/turn light: 1 per side (7.5 amps)
• Max. tail lights: (7.5 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
ENGLISH
TOOLS RECOMMENDED:
Dr
ill (3/32” Drill Bit),
Philips Head Screwdriver
1. Locate the v
ehicle wiring inside the
vehicle's trunk. Start by removing each
of the plastic wing nuts located behind
the taillights
de
.
Carefully pull back
the carpet to expose the vehicle’s taillight
wiring
f
.
2. Beginning with the dr
iver's side, slide the
red loc
king tab on the harness connector
to the unlocked position and disconnect
the wire harness from sockets. There will
be connection points matching the ends
of the T-Connector adapter. All connector
surfaces should be clean and free of dirt.
Attach each end to the T-Connector
containing the
y
ellow
wire
. Be sure that
connectors are fully inserted with locking
tabs in place.
3. Route the connector containing the green
wire do
wn the threshold to the passenger
side of the vehicle
g
.
Push the wiring
between the vehicle body and carpet.
Repeat step 2 for T-Connector end with
the
green wire
.
4. Locate a suitab
le grounding point near
the adapter such as the vehicle frame
or crossmember. (Do not drill into vehicle
floor or bed). Clean dirt and rustproofing
from the area. Drill a 3/32" hole and
secure the
white wire using the e
yelet
and screw provided.
18404-037
Rev. A
05/20/05
READ
THIS FIRST:
Read and f
ollow all instructions carefully
before beginning installation.
LISEZ CECI EN PREMIER:
Lire et suivre toutes les instr
uctions
attenrivement avant le montage.
LEA
ESTO PRIMERO:
Lea y siga todas las instr
ucciones cuidadosa-
mente antes de iniciar la instalación.
•
d
•
f
•
g
•
e
Installation Instr
uctions
Directives de Montage
Instrucciones de Instalación
T-Connector
Connecteur en T
Conector en T