AGFA DC-1338i - Manual (Page 8)

8
Batteries and rechargeable batteries should not be thrown in the trash can. Please return used
batteries to the store or take it to where they collets such items. Following this guideline we are
helping not to polluting our environment.
Declaration of Conformity
We herewith confirm the following designated product: AGFAPHOTO digital camera DC-1338i has
been tested and found to comply with the requirements set up in the council directive on the
approximation of the law of members’ states relating to the EMC Directive 2004/108/EC.
For the evaluation regarding to the electromagnet compatibility, the
following standards were applied
EN 55022:2006, Class B
IEC 61000-3-2:2005
IEC 61000-3-3:2005
EN 55024:1998+A1:2001+A2:2003
IEC 61000-4-2:2001
IEC 61000-4-3:2006
IEC 61000-4.4: 2004
IEC 61000-4-5:2005
IEC 61000-4-6:2006
IEC 61000-4-8:2001
IEC 61000-4-11:2004
The device is marked with CE Logo.
FCC Compliance and Advisory
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: 1.) this device may not cause harmful interference, and 2.) this device must accept any
interference received, including interference that may cause unsatisfactory operation. This equipment
has been tested and found to comply with the limits for a Class B peripheral, pursuant to Part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference
in a residential installation. This equipment generates, uses, and can radiate radio frequency energy
and, if not installed and used in accordance with the instructions, may cause harmful interference to
radio communication. However, there is no guarantee that interference will not occur in a particular
installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the
interference by one or more of the following measures.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.