Draw-Tite 20271 WIRING ADAPTER - Manual

20271-037 Rev. A 09/30/08
Installation Instructions
Directives de Montage
Instrucciones de Instalación
Electronic Trailer Brake Control
Wiring Adapter
Adaptateur pour câblage de commande
de frein de remorque électrique
Adaptador del cableado de control
eléctrico del remolque
•
d
•
e
READ THIS FIRST:
Read and follow all vehicle warnings and installation
instructions before beginning installation. Wear safety
glasses and use all safety precautions during installation.
LISEZ CECI EN PREMIER:
Lire et observer toutes les consignes de sécurité et les
instructions avant de commencer l’installation. Durant
l’installation, veiller à toujours porter des lunettes de
protection et respecter les mesures de sécurité.
LEA ESTO PRIMERO:
Lea y siga todas las advertencias e instrucciones de
instalación del vehículo antes de empezar la instalación.
Use gafas de seguridad y todas las precauciones de
seguridad durante la instalación.
RED: VEHICLE STOP LAMP SWITCH
TO BRAKE CONTROLLER (INPUT)
ROUGE: COMMUTATEUR DE FEUX D'ARRÊT
DU VÉHICULE AU CONTROLE DE FREINS
ROJO: INTERRUPTOR DE LUCES DE FRENADO
DEL VEHICULO AL CONTROLADO
DE FRENO (ENTRADA)
Wiring Adapter Housing
(containing Male Terminals) -
Wire Side Logement de l'adaptateur de
câblage (contenant les bornes
mâles) - Côté fil Protector del adaptador de
cables (contiene los terminales
machos) - Alambre el lado
WHITE: GROUND
BLANC: MISE À LA TERRE
BLANCO: TIERRA
BLACK: FUSED TRAILER BRAKE
CONTROLLER BATTERY FEED
NOIR: ALIMENTATION À FUSIBLE DE LA
BATTERIE AU CONTRÔLE DE FREINS
NEGRO: CONDUCTOR (CON FUSIBLE) DE LA
BATERIA AL CONTROLADOR DEL
FRENO DEL REMOLQUE
BLUE: TRAILER BRAKE CONTROLLER
(OUTPUT)
BLEU: CONTRÔLE DE FREIN DE REMORQUE
(SORTIE)
AZUL: CONDUCTOR DEL CONTROLADOR DE
FRENO (SALIDA) AL FRENO ELÉCTRICO
DEL REMOLQUE
ENGLISH
1. Locate the vehicle’s electric brake
control harness. The harness will be
located underneath the dash and left
of the steering column, taped to another
harness near the emergency brake pedal
d. There will be a 4-pin connector that
mates with the one on the adapter
e.
2. Plug the brake control adapter into
the vehicle electric controller connector.
Use butt connectors and attach the wires
from the adapter to the corresponding
wires on the electric brake control,
following the brake control manufacturer's
installation instructions.
3. Complete the installation per the electric
brake control manufacturer’s instructions
and mount the unit as directed. Perform
test procedures as instructed.
NOTE
Vehicles not equipped with OEM trailer
tow package, may require fuses and
relays to complete output and battery
feed circuits (sold separately). Consult
owners manual for locations.
WARNING
Overloading circuit can cause fires.
DO NOT exceed lower of towing
manufacturer rating or:
• Max. 3 AXLES: 6 BRAKES (18 amps)
Read vehicle's owners manual &
instruction sheet for additional information.
KIA Borrego
Emergency brake pedal
Pédale de frein de secours
Pedal de freno de emergencia
4-pin connector
Connecteur à 4 broches
Conector de 4 patas
4-pin connector
Connecteur à 4 broches
Conector de 4 patas