Draw-Tite 75172 MAX-FRAME RECEIVER - Manual

Installation Instructions
CADILLAC ESCALADE,
CADILLAC ESCALADE EXT,
CADILLAC ESCALADE ESV
Part Numbers:
75172
44145
Hitch Shown In Proper Position
Equipment Required:
Wrenches: 7/8, 22mm
Drill Bits: None
Rev. C 7-24-06 N75172 Sheet 1 of 3 z 2002, 2003, 2006 Cequent Towing Products
Note: check hitch frequently, making sure all fasteners and ball are properly tightened. If hitch is removed, plug all holes in trunk pan or other body panels to
prevent entry of water and exhaust fumes. A hitch or ball which has been damaged should be removed and replaced. Observe safety precautions when working
beneath a vehicle and wear eye protection. Do not cut access or attachment holes with a torch.
This product complies with safety specifications and requirements for connecting devices and towing systems of the state of New York, V.E.S.C. Regulation V-5
and SAE J684.
Fastener Kit: F75172
Do Not Exceed Lower of Towing Vehicle
Manufacturer’s Rating or
600 (272 Kg) 6000 (2724 Kg)
Weight Carrying
Ball Mount
750 (341 Kg) 7500 (3405 Kg) Weight Distributing
Max Tongue
WT (LB)
Max Gross
Trailer WT (LB)
Hitch type
Wiring Access Location: SUV6
Tighten all 1/2 GR5 fasteners with torque wrench to 75 Lb.-Ft. (102 N*M)
Tighten all M14 CL10.9 fasteners with torque wrench to 115 Lb.-Ft. (156 N*M)
Hex Nut 1/2-13 Qty. (2) 4
Flat Washer Qty. (4) 7 Conical Washer Qty. (2) 3
Lock Washer Qty. (4) 6 Spacer Qty. (2) 2
Hex Bolt M14 X 2.00 X 40mm Qty. (4) 5 Carriage Bolts 1/2-13 X 1.75 Qty. (2) 1
1. Remove existing M14 bumper bracket bolts on both sides from bottom surface of frame and return to vehicle owner.
2. Raise hitch into position and install as shown with fasteners provided.
Note: Fasteners typical
both sides
7
6
5
1
2
3
4
Frame rail
Bumper
Bumper bracket
Existing weldnut
Existing weldnut
Inside of bumper
Bumper
Frame rail
3
4
Form: F205 Rev A 5-6-05