Datamax-O'Neil A-Class Mark II RFID Quick Start Guide - Manual (Page 3)

2
This guide presents a systematic overview of important media requirements, setup options, and modes of
use for A-Class Mark II RFID-equipped printers.
 Note: To use the RFID option, the printer’s firmware version must be 12.03 or greater. Downloads can be
found at ftp://ftp.datamax-oneil.com/Printer Firmware .
Step 1: Know the RFID Media
Ensure that your UHF RFID media meets the following specifications:
Smart Label and Tag Requirements [1]
Layout
C
D
E
B
A
Forward
Movement
Definitions
[2]
Designator Description Dimension (inches) Dimension (millimeters)
A Label Width 4.00 101.6
B Label Lengths 2.00, 4.00, & 6.00 50.8, 101.6, & 152.4
C Chip Location Tolerance ± 0.05 ± 1.3
D Label Pitch (minimum) 1.70 57.2
E Chip Inlay Location 1.10 27.9
[1]
See the Operator’s Manual for additional standard media requirements.
[2] Definitions referenced while looking down onto the labeling side of the media, and from the leading edge of the
label (or tag) in the print direction.
 Note: If you have questions regarding media selection, contact a Datamax-O’Neil Media Representative at
(407) 523-5650.