Avision AM7100NF User Manual - Manual (Page 85)

78
Using Duplex Mode and Select Binding Orientation
To use duplex mode, you need to purchase and install a duplex module first.
To use duplex mode and select binding orientation,
1 Place your document either on the flatbed glass or into the ADF input tray.
2
Press the Menu button on the control panel. The LCD-display shows the
following Menu screen.
Menu/to select
Press WX, Num
3 Press the Set, the Left-arrow or the Right-arrow button. The LCD shows
“1. Common Setup”.
1. Common Setup
Press WX, Set
4 Press the Set button and then the Left-arrow or the Right-arrow button
repeatedly until “14. Output Mode” is displayed.
14. Output Mode
Press WX, Set
5 Press the Set button and then the Left-arrow or the Right-arrow button
until Duplex is displayed.
Duplex
Press WX, Set
6 Press the Set button to choose the selection. If successfully, the LCD
shows “Setting OK”.
Duplex
Setting OK
7 Press the Back button and then the Right-arrow or the Left-arrow button
repeatedly until “Duplex Setting” is displayed.
15. Duplex Setting
Press WX, Set