Aeromotive 17141 - 96-04 4.6L SOHC GT A1000 FUEL SYSTEM User Manual
Page 7
Section 3 – Fuel Regulator Installation and Fuel Line Plumbing
3-1. In the vehicle’s engine compartment, mount the supplied fuel pressure regulator in the location established in step 1-
26. Using the supplied mounting bracket as a template, mark the bracket mounting holes and drill to accept a #10
screw.
3-2. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two #10 screws, nuts
and lock washers.
3-3. Install two of the supplied AN-10 o-rings on the cutoff side of two AN-10 cutoff to AN-08 reducer union fittings, if not
already installed, and install in each of the AN-10 ports located on the sides of the supplied fuel pressure regulator.
3-4. Install one of the supplied AN-06 o-rings on the cutoff side of the AN-06 cutoff union fitting, if not already installed,
and install in the AN-06 port located on the bottom of the supplied fuel pressure regulator.
3-5. Install two of the supplied AN-08 o-rings on the cutoff side of two AN-08 cutoff union fittings, if not already installed.
3-6. Install these two AN-08 fittings on the rear side of each fuel rail.