Aeromotive 17241 - BB CHEVY BELT DRIVE KIT - Manual (Page 3)

8. Locate the two 7/16” mounting holes on the block, looking at the front of the engine block there will be two 7/16”
threaded holes oriented vertically from each other to the right of the crankshaft. Thread each of the spacer / stud
assemblies into each of the two mounting holes and tighten.
9. Thread the 1/4-28 x 1 socket head cap screw into the bracket but do not tighten.
10. Slide the bracket onto the pump in the orientation shown below;
11. Using the two 3/8-16 X 1” bolts and two 3/8” flat washers attach the fuel pump bracket to the spacers; leave the
assembly loose until final alignment can be determined.