Aeromotive 17242 - A1000 CARBURETED FUEL SYSTEM (SINGLE CARB) User Manual
Page 6
Section 2 – Fuel Regulator Installation and Fuel Line Plumbing
2-1. In the vehicle’s engine compartment, mount the supplied fuel pressure regulator in the location established in step 1-
15. Using the supplied mounting bracket as a template, mark the bracket mounting holes and drill to accept a #10
screw.
2-2. With the bracket attached to the regulator, mount the bracket and regulator to the vehicle using two #10 screws, nuts
and lock washers (not provided).
2-3. Install two of the supplied AN-06 o-rings on the cutoff side of two AN-06 cutoff union fittings, if not already installed,
and install in each of the AN-06 ports located on the sides of the supplied fuel pressure regulator.
2-4. Install the supplied AN-08 o-rings on the cutoff side of the AN-08 cutoff union fitting, if not already installed, and install
in the AN-08 port located on the bottom of the supplied fuel pressure regulator.
2-5. Install one of the supplied AN-10 o-rings on the cutoff side of the AN-10 cutoff union fitting, if not already installed,
and install in the AN-10 port located on the front of the supplied fuel pressure regulator.
2-6. Place the crush rings on the dual feed carburetor to AN-06 adapter fittings. Thread each of the two fittings into each of
the carburetor float bowls and tighten. If you are using a carburetor other then a dual feed style, you will have to make
alternate accommodations for an AN-06 fuel supply line.