Extron Electronics MMX 32 MAAP Installation - Manual

Installation Guide
Extron Electronics, USA
1230 South Lewis Street
Anaheim, CA 92805
USA
714.491.1500
Fax 714.491.1517
Extron Electronics, Europe
Beeldschermweg 6C
3821 AH Amersfoort
The Netherlands
+31.33.453.4040
Fax +31.33.453.4050
Extron Electronics, Asia
135 Joo Seng Road, #04-01
PM Industrial Building
Singapore 368363
+65.6383.4400
Fax +65.6383.4664
Extron Electronics, Japan
Kyodo Building
16 Ichibancho
Chiyoda-ku, Tokyo 102-0082 Japan
+81.3.3511.7655
Fax +81.3.3511.7656
www.extron.com
© 2005 Extron Electronics. All rights reserved.
68-881-01 Rev. C
11 05
Contact Closure Control Panels for the MMX 32 VGA A
Mini Matrix Switcher
MMX 32 AAP and
MMX 32 MAAP
Connecting the control panel to an MMX 32 VGA MTP
See the drawing below. The wire connected to the 5 VDC pole
( 4 on pages 2 and 3) should not be daisy chained. The power for
each AAP or MAAP must come directly from the +5V connector
for the appropriate output on the MMX switcher.
See the drawing below. The wire connected to the Ground pole
( 5 on pages 2 and 3) should not be shared or jumpered between
two AAPs and/or MAAPs. Run a separate ground wire for each
AAP and/or MAAP. Use the drain wire of the cable for ground.
The drawing below shows a control panel wired to select the input
tied to MMX 32 VGA MTP output 1, using the Remote 1 captive
screw connector. To select the input tied to output 2, use the
Remote 2 captive screw connector.
L R
INPUT 2
INPUT 1
AUDIO
AUDIO
OUTPUT 1
AUDIO
INPUT 3
AUDIO
REMOTE
AUDIO
RS-232
+5V POWER
12V
0.5A MAX
2
1
1 2 3
Tx Rx
SYNC -
TRI
PRE PEAK - ON OUTPUT 2
RGB/AUDIO
MMX 32 AAP
MMX 32 VGA MTP
Red +5V
Extron
STP 22 Dual Plenum
Cable 22-162-03
White
CONT
A C T
Green Blac
k
Ground ( )
Wiring diagram for a typical MMX 32 VGA MTP application
Recommended Cables
STP22P 1000’ (305 m) Dual Plenum in self-dispensing box 22-162-03
STP22 1000’ (305 m) Dual in self-dispensing box 22-160-03