Extron Electronics MK Faceplate - Manual

1 EC and MK Model Faceplates • Installation Guide
EC and MK Model Faceplates Installation Guide
68-986-01 Rev. B
Printed in the USA
07 04
This guide provides instructions on installing an Extron MLC or SCP controller into
a Euro Channel using an EC model faceplate, or into an MK wall box using an MK
model faceplate.
Controllers and AAPs are not included with any of the faceplates.
Installing an MLC or SCP Controller Using an EC Faceplate
To install the MLC or SCP controller using the EC faceplate:
1 . Replace the controller’s standard faceplate with the EC model faceplate.
a . Use a small Philips screwdriver to remove the faceplate attachment
screws.
b . Lift the faceplate off the controller.
c . Align the openings in the new faceplate with the controller’s buttons,
knob, and LEDs, and place the new faceplate on the controller.
d . Replace the screws removed in step a, and hand tighten them.
2 . With power disconnected at the source, insert the controller and EC model
faceplate into the Euro Channel. For wider types of Euro Channels, you may
need to insert a spacer plate first.
3 . Mount the controller to the Euro Channel by attaching the faceplate to the two
backing plates using four #6-32 mounting screws. See the illustration below.
(The illustration shows the MLC 206 with the MLM 206 AAP EC faceplate, but
this procedure is the same for all the EC model faceplates).
Make sure that the Euro Channel is grounded to an earth ground before
completing the installation.
Euro Channel
MLM 206 AAP EC
MLC 206
Backing Plate
DI SP LA Y
PO W ER
VO LU ME
MA X/ MI N
VC R
DV D
La pto p
Le cte rn
Co mp ute r
Do cu me nt
Ca me ra Au xilia ry
Vid eo
Mounting the controller and EC model faceplate to a Euro Channel