Configuration, Introduction, Configuring the curie in ooibase32 – Ocean Optics Curie UV-VIS Emission User Manual
Page 15: Initial start-up, Operator and serial number dialog box, Chapter 2: configuration, Chapter 2
Chapter 2
Configuration
Introduction
This chapter provides instructions for configuring the OOIBase32 Configure Spectrometer options so that
the application recognizes your connected Curie system.
Configuring the Curie in OOIBase32
Once the Curie system is installed (see
), you must configure
OOIBase32’s Configure Spectrometer options so that the application recognizes the connected Curie
system and its components.
Note
See the OOIBase32 Spectrometer Operating Software, Operating Instructions for
detailed instructions on configuring your spectrometer in OOIBase32. See
for information on locating this document.
Initial Start-up
The following sections provide information for initially configuring the Curie system in OOIBase32.
With your Curie attached to the computer via the USB port and plugged into the wall power outlet, start
the OOIBase32 software application.
Operator and Serial Number Dialog Box
The Operator and Serial Number dialog box prompts you to enter a user name and software serial
number into OOIBase32. Some of the data files use this information in the data file headers. Since
OOIBase32 is free software, it requires no serial number for installation. You can leave the field as is.
640-11100-000-02-0406
9