beautypg.com

Powersolve SR05-12 Series User Manual

Dc-dc switching regulator, Features

background image

Powersolve Electronics Ltd.  8A Arnhem Road,  Newbury, RG14 5RU.  England

Tel: 01635 521858  Fax: 01635 523771  Email: [email protected]

www.powersolve.co.uk

DC-DC Switching Regulator

SR05-12 Series
5A SIP & SMT Packages
Non-Isolated

Features

Non-Isolated POL Converter

SIP / SMT Packages

Output Current 5A

Input Voltage Range 8.3 - 14VDC

Output Voltage Range 0.75 - 5VDC

Efficiency to 92%

Over Temperature Protection

Continuous Short Circuit Protection

Remote On/Off Control

INPUT
Input Voltage Range

8.3 - 14V (12V nominal)

Under Voltage Lock-out

8.0V typ. (Power Up)
7.9V typ. (Power Down)

Input Filter

Capacitive

Remote On/Off Control

Open Circuit or equal to Vin (Module On)
<0.4VDC (Module Off)

OUTPUT
Voltage Accuracy

±1.5% max.

Transient Response: 25% step load change

<200µ sec.

Ripple and Noise (20MHz BW) [3]

20mV rms, 50mV pk-pk max.

Vo = 5VDC

45mV rms, 75mV pk-pk max.

Temperature Coefficient

±0.03% / °C

Short Circuit Protection

Continuous

Line Regulation [1]

±0.2%

Load Regulation [2]

±0.5%

Capacitive Load, Low ESR

3000µF max.

External Trim Adj. Range (see table)

Vo = 0.75 - 5.0VDC

GENERAL
Efficiency

See Table

Isolation Voltage

Non-Isolated

Switching Frequency

300KHz typ.

Over Temperature Protection

120°C typ.

Operating Temperature Range

-40°C to +85°C

Power Derating

See derating curves

Storage Temperature Range

-55°C to +125°C

Dimensions

22.9 x 10.16 x 5.6 mm (0.90 x 0.40 x 0.22 Inches) (SIP Package)
20.3 x 11.43 x 6.09 mm (0.80 x 0.45 x 0.24 Inches) (SMT Package)

Case

Non-potted open frame type

Weight

2.3g

Electrical Specification

Typical at nominal line, full load & 25°C unless otherwise stated.

NOTE:
1. Measured from High Line to Low Line (Vo set to 1.8VDC).
2. Measured from Full Load to No Load (Vo set to 3.3VDC).
3. Output noise & ripple is measured with a 10µF tantalum & 1µF ceramic capacitor across the output.
4. It is recommended to put a 100µF capacitor with ESR<100mΩ across the input to reduce the input ripple voltage.
5. Suffix ‘N’ to model number for Negative Logic Remote On/Off Control.