Powersolve JB300 Series - Manual (Page 2)

www.powersolve.co.uk
Powersolve Electronics Ltd. 8A, Arnhem Road, Newbury, RG14 5RU. England
Tel:01635 521858 Fax: 01635 523771 Email: [email protected]
AC-DC Converters
OUTPUT VOLTAGE/CURRENT RATING CHART: Measured at output power connector
OUTLINE DRAWING
Notes:
* JB300DX-Y series are designated as JB300Dx-y where x can be U (U-Chassis), C (U-Chassis with top cover), E (Enclosed Type with side
built-in Fan) or F (Enclosed Type with side built-in Fan); y can be 0512, 0524, 0548, 1224.
* JB300DU (with min. 18CFM forced air flow) & JB300DE & JB300DF Series:
Max. 300W total combined power of V1 and V2 for JB300Dx-1224 and 250W for other models.
* JB300DU and JB300DC Series with convection cooling:
Max. 150W total combined power of V1 and V2 for JB300Dx-1224 and 125W for other models.
* Ripple and noise is measured from 10KHZ to 20MHz bandwidth at output with parallel 0.1uF ceramic and 22uF electrolytic capacitors.
* 10% minimum load is required to maintain the ripple and regulation.
* Output is fully isolated.
Max. Output Current
Model Output Voltage Type U (force air) Type U, C Regulation Ripple & Noise
& E & F (Convection)
JB300Dx-0512
V1: +5V 30A 15A +/- 5% 1%
V2: +12V 16.67A 10.42A +/- 5% 1%
JB300Dx-0524
V1: +5V 30A 15A +/- 5% 1%
V2: +24V 8.33A 5.2A +/- 5% 1%
JB300Dx-0548
V1: +5V 30A 15A +/- 5% 1%
V2: +48V 4.16A 2.6A +/- 5% 1%
JB300Dx-1224
V1: +12V 16.67A 12.5A +/- 5% 1%
V2: +24V 8.33A 6.25A +/- 5% 1%
Howder Molex
Pin 1: V1 Pins 1 ~ 3: V1
Pin 2 ~ 3: RTN Pins 4 ~ 8: RTN
Pin 5: GND Pin 12: GND
Pin 4: V2 Pins 9 ~ 10: V2
Pin 6: Neutral Pin 14: Neutral
Pin 7: Line Pin 16: Line
Pin Connections
Input and Output Connector (CN2):
Howder Terminal block Part No. HB-95-7P or Mating Molex Part No. 09-91-1600
(16 pin).
Output Pin Assignment:
(See table in right).
Mounting Inserts:
8 Places M4X0.7 (8-32 Optional). Maximum Penetration 4mm sees outline drawing
for location.
Logic signal connector (CN1):
Mating JST XHP-3 or equivalent (CHYAO SHIUNN JS-2001-03);
Mating Pins: JST SXH-002T-P0.6 FOR AWG 30 to 26.
Fan driver connector (FAN2):
Mating connector is a Molex P/N 22-01-1022 ( 2 pins 0.98 pitch) or equivalent with
Series 2759 or 5159 terminals.