Peerless-AV HLC-KIT-Q10 - Installation - Manual (Page 2)

2 of 3 ISSUED: 12-02-10 SHEET #: 120-9099-1
Attach larger diameter end of safety cable ( A) to back of display as shown using back of
display hardware provided ( C-G).
WARNING: Safety cable is not to support the weight of the display.
1
2
Attaching Safety/Security Cable to Display
A
DISPLAY ATTACH SAFETY CABLE TO BACK
OF DISPLAY USING DISPLAY
HARDWARE PROVIDED ( C-G)
AS SHOWN
USE LARGER DIAMETER END
Remove one stand mounting screw (provided with display) and replace it with display stand neck hardware
provided ( H-R).
NOTE: Verify that washer diameter is smaller than the recess it is going into. Not doing so may result in difficulty
removing the washer.
DISPLAY
REPLACE EXISTING HARDWARE WITH
DISPLAY STAND NECK HARDWARE ( H-R)