Warning, Caution, Da d c – Peerless-AV FPEWM - Installation User Manual

Page 6

6 of 21

ISSUED: 08-09-10 SHEET #: 061-9057-5 03-04-11

All other brand and product names are trademarks or registered trademarks of their respective owners.

Insert two M10 x 16 mm socket screws (C) and
two split lock washers (D) into bottom of wall box
(A) leaving 1/4" exposed thread as shown in fi gure
3.1 and detail 1.

Hook tilt plate (B) onto bottom socket screws
threaded into wall box (A) and select desired tilt
angle (0° to 20°) as shown in fi gure 3.2. NOTE: Be
sure split lock washer (D) is on outside of tilt plate
as shown in detail 2.

Insert two M10 x 16 mm socket screws (C) and
two split lock washers (D) through tilt plate (B)
and into top of wall box (A) as shown in fi gure 3.3.
Tighten all fasteners using 6 mm allen wrench.

Mounting Main Enclosure Assembly

• Do not lift more weight than you can handle. Always use an assistant or mechanical lifting equipment to safely lift

and position the fl at panel screen.

• Do not tighten screws with excessive force. Overtightening can cause damage to mount. Tighten screws to

40 in. • lb (4.5 N.M.) maximum torque.

WARNING

• Do not allow main enclosure assembly to hang freely

on wall box (A) when all four sets of M10 x 16 mm
socket screws (C) are not fully secured or mount may
come off of wall.

CAUTION

fi g 3.2

fi g 3.3

MAIN ENCLOSURE
ASSEMBLY

TILT PLATE

DETAIL 2

DETAIL 1

fi g. 3.1

1/4"