Assembly, Important – BabyTrend HC01428 - TREND HIGH CHAIR - MOJITO User Manual

Page 3

IMPORTANT!

To ensure safe operation of your product,

please follow these instructions carefully. Please keep these

instructions for future reference.

IMPORTANT!

Before assembly and each use, inspect this

product for damaged hardware, loose joints, missing parts or sharp

edges. NEVER use if any parts are missing or broken.

IMPORTANT!

Adult assembly is required.

IMPORTANT!

Always check that the high chair is locked

in the open position before using.

ATTENTION:

Carefully remove parts from box. Check that you

have all the parts for this model before assembling

the high chair. NOTE: Certain High Chair models

are packaged with the High Chair Seat Fabric and

Seat Insert already attached to the Seat Back.

TO ASSEMBLE SEAT

1. Place the Seat Base on a flat surface as shown

in figure 1.

2. Join the Seat Back to the Seat Base using the

Seat Back Hinge Rod as shown in figure 2.

The rod is inserted from right to left as shown.

Fig. 1

ASSEMBLY

Fig. 4

Fig. 2

3. Slide the left and right sides’ Height Bracket

onto the Seat Base (Fig. 3). Snap the brackets

in place (Fig. 4).

4. Slide the Footrest onto the Seat Base as shown

in Figure 5. Snap Footrest into place.

5. Insert the front tube of the right side Upper

Frame Assembly into the Height Bracket

(Fig. 6). The front tube is easily distinguished

from the rear tube by the array of holes located

on the backside of the tube.

6. Squeeze the Red Release Handle and push the

tube through the Height Bracket until it locks

on the highest position (Fig. 7).

7. Repeat Steps 5 and 6 for the left side Upper

Frame Assembly (Fig. 8).

Fig. 3

Fig. 5

Seat Back

Seat Base

Seat Back

Hinge Rod

Height Bracket

Footrest

Upper Frame Assembly

Height Bracket

Red Release

Handle

Fig. 6

Fig. 7

Fig. 8