BabyTrend 8625 - LAUREL OAK HIGH CHAIR - Manual (Page 4)

5. Align the footrest with the seat base as shown in figure 5.
6. A: Snap footrest into place with the seat base, B: Insert
the seat brace through the seat base rings and footrest as
shown in figure 6.
7. Align the holes on the seat brace with the holes in the
bottom of the seat base as shown in figure 7.
Figure 5
Footrest
8. Slide the left and right sides height bracket onto the end of
the seat brace as shown in figure 8.
9. Rotate height bracket until it snaps into locking tab located
on the seat base. See figure 9.
10. Secure the height brackets to the seat brace with the
2 (3.5mm x 10) screws provided. Please see figure 10.
Tighten the screws until snug: DO NOT OVER-TIGHTEN .
Check that the height brackets are securely attached to
the seat.
11. Insert the front tube of the right side upper frame assembly
into the height bracket as shown in figure 11. The front
tube is easily distinguished from the rear tube by the array
of holes located on the backside of the tube. Squeeze the red
release handle and push the tube through the height bracket
until it locks on the highest position. See figure 12.
Figure 9
Attach
3.5mm x 10
screw here
Seat Brace
Figure 6
Figure 7
Footrest
Height
Bracket
Figure 8
Seat
Brace
Figure 10
A
B
Upper Frame
Assembly
Height
Bracket
Figure 11
Red Release
Handle
4