Rainbow Electronics AT27C512R - Manual (Page 3)

AT27C512R
3
Block Diagram
Notes: 1. X can be V
IL
or V
IH
.
2. Refer to Programming Characteristics.
3. V
H
= 12.0
±
0.5V.
4. Two identifier bytes may be selected. All Ai inputs are held low (V
IL
), except A9 which is set to V
H
and A0 which is toggled low
(V
IL
) to select the Manufacturer’s Identification byte and high (V
IH
) to select the Device Code byte.
Absolute Maximum Ratings*
Temperature Under Bias ............................... -55°C to + 125°C *NOTICE: Stresses beyond those listed under “Absolute Maxi-
mum Ratings” may cause permanent damage to
the device. This is a stress rating only and func-
tional operation of the device at these or any other
conditions beyond those indicated in the opera-
tional sections of this specification is not implied.
Exposure to absolute maximum rating conditions
for extended periods may affect device reliability.
Note: 1. Minimum voltage is -0.6V dc which may undershoot
to -2.0V for pulses of less than 20 ns. Maximum
output pin voltage is V
CC
+ 0.75V dc which may
overshoot to +7.0 volts for pulses of less than 20 ns.
Storage Temperature .................................... -65°C to + 150°C
Voltage on Any Pin with
Respect to Ground ........................................-2.0V to + 7.0V
(1)
Voltage on A9 with
Respect to Ground .....................................-2.0V to + 14.0V
(1)
V
PP
Supply Voltage with
Respect to Ground ......................................-2.0V to + 14.0V (1)
Operating Modes
Mode\Pin CE OE/V
PP
Ai Outputs
Read V
IL
V
IL
Ai D
OUT
Output Disable V
IL
V
IH
X (1) High Z
Standby V
IH
X (1) X High Z
Rapid Program (2) V
IL
V
PP
Ai D
IN
PGM Inhibit V
IH
V
PP
X (1) High Z
Product Identification (4) V
IL
V
IL
A9 =V
H
(3)
A0 = V
IH
or V
IL
A1 - A15 = V
IL
Identification Code