Rainbow Electronics W90P710CDG - Manual (Page 7)

W90P710CD/W90P710CDG
Publication Release Date: September 19, 2006
- 7 - Revision B2
Ethernet MAC Controller
y
DMA engine with burst mode
y MAC Tx/Rx buffers (256 bytes Tx, 256 bytes Rx)
y Data alignment logic
y Endian translation
y 100/10-Mbit per second operation
y Full compliance with IEEE standard 802.3
y RMII interface only
y Station Management Signaling
y On-Chip CAM (up to 16 destination addresses)
y Full-duplex mode with PAUSE feature
y Long/short packet modes
y PAD generation
LCD Controller (LCDC)
(1) STN LCD Display
y Supports 4-bit single scan Monochrome STN LCD panel, 8-bit single scan Monochrome STN LCD
panel, 8-bit single scan Color STN LCD panel
y Up to 16 gray levels display for Monochrome STN LCD panel
y Up to 4096(12bpp) colors display for Color STN LCD panel
y Virtual coloring method: Frame Rate Control (16-level)
y Anti-flickering method: Time-based Dithering
(2) TFT LCD Display
y Supports Sync-type TFT LCD panel and Sync-type High-color TFT LCD panel
y Supports direct or palettized color display
(3) TV Encoder
y Supports 8-bit YCbCr data output format to connect with external TV Encoder
(4) LCD Preprocessing
y Supports RGB Raw-data or packetd YUV422 format
y Programmable parameters for different image size
y Build in two FIFOs, FIFO 1 is for Video image and FIFO 2 is for OSD image. Each FIFO is 16
words deep