Cobalt Digital COMPASS 9034 Input Processing Analog to Digital Video User Manual

Page 34

Installing the 9034 Into a Frame Slot

2-4

9034 PRODUCT MANUAL

9034-OM (V4.1)

Repeat steps 1 through 8 for other 9034 cards.

Note:

The 9034 BNC inputs are internally 75-ohm terminated. It is not necessary to
terminate unused BNC inputs or outputs.

Note:

External frame sync reference signals are received by the card over a refer-
ence bus on the card frame, and not on any card rear I/O module connectors.
The frame has BNC connectors labeled REF 1 and REF 2 which receive the
reference signal from an external source such as a house distribution.

Note:

To remove a card, press down on the ejector tab to unseat the card from the
rear I/O module mating connector. Evenly draw the card from its slot.

10.

If network remote control is to be used for the frame and the frame has
not yet been set up for remote control, perform setup in accordance with
Cobalt

reference guide “COMPASS™ Remote Control User Guide”

(PN 9000RCS-RM).

Note:

If installing a card in a frame already equipped for, and connected to
DashBoard™, no network setup is required for the card. The card will be dis-
covered by DashBoard™ and be ready for use.