Rough Country 1328BOX4 User Manual
Page 2
3. Swing the bar up to the transmission cross-member and mark the holes to be drilled. See Photo 3.
4. Drill holes using a 1/2” drill bit. See Photo 4.
5. Install the kicker to the transmission cross-member using the supplied 1/2” x 1” bolt , washer and nuts. See Photo 5.
6. Tighten using a 19mm socket and wrench to tighten the kicker to the cross-member and the transmission cross-
member. See Photo 6.
7. Repeat for opposite side.
PHOTO 3
PHOTO 4
PHOTO 5
PHOTO 6
POST INSTALLATION
All components must be retightened after 500 miles, and every three thousand miles after installation.
Thank you for using Rough Country Suspension for your off road needs!!
MARK HOLES TO BE DRILLED
DRILL HOLE USING 1/2” DRILL BIT
INSTALL KICKER TO TRANS CROSS-MEMBER
TIGHTEN ALL HARDWARE
- PERF689 (12 pages)
- 1308 (4 pages)
- 576.20 (16 pages)
- 1010 (4 pages)
- 787.22 (14 pages)
- 282 (14 pages)
- 1098 (1 page)
- 598S (17 pages)
- 379.22 (8 pages)
- 1051 (1 page)
- 392.24 (6 pages)
- 1109 (2 pages)
- 1011 (4 pages)
- 263.22 (9 pages)
- 7599 (4 pages)
- 1169 (2 pages)
- 87496 (4 pages)
- 288.20 (8 pages)
- 324S (20 pages)
- 283N2 (2 pages)
- PERF677 (8 pages)
- 699 (2 pages)
- 1305 (4 pages)
- 774S (10 pages)
- 1403 (2 pages)
- 9219 (2 pages)
- 1186 (1 page)
- 592.20 (8 pages)
- 1113 (2 pages)
- 563.20 (8 pages)
- 1054 (4 pages)
- 479.20 (8 pages)
- 87349 (2 pages)
- 280N2 (12 pages)
- 1021 (4 pages)
- RC0342 (2 pages)
- 3592 (2 pages)
- 1776 (1 page)
- 1182 (1 page)
- 1040 (2 pages)
- 561.20 (4 pages)
- 1117 (4 pages)
- 75113-15 (16 pages)
- PERF662X (8 pages)
- 1156 (2 pages)