Veris Industries TWS SERIES Install User Manual

Page 3

VERIS INDUSTRIES

™

inStallation GUiDe

tWS SerieS

Z204455-0D

PAGE 3

06101

Alta Labs, Enercept, Enspector, Hawkeye, Trustat, Veris, and the Veris ‘V’ logo are trademarks or registered trademarks of Veris Industries, L.L.C. in the USA and/or other countries.

menu

tws calibration instructions

Temperature calibration allows for calibration offset of ±9.9°F (±5°C) at user
discretion. Temperature can be field calibrated by moving the RUN/CAL jumper to CAL
position.

O U T P U T

0 - 1 0 V

T E M P S E T
+ 5 0

+ 9 5

C A L

+ 0 . 0

6 8 . 5

º F

U N I T S
* º F

º C

S E T P O I N T

7 0

S E T P O I N T

7 0

SETPOINT MODE

(Enter by any keypress when RUN/CAL

jumper is in RUN position)

NORMAL MODE

press± to change; press* to select

(setpoint in ˚C if Celsius units are selected)

press± to change; press* to select

(setpoint in ˚C if Celsius units are selected)

press± to change; press* to select

(cal in ˚C if Celsius units are selected)

press± to change; press* to select

(choices are 50-95˚F/10-35˚C or 32-122˚F/0-50˚C)

CONFIG/CAL MODE

(Enter by any keypress when RUN/CAL

jumper is in CAL position)

Output scaling

(does not affect LCD display)

Only for switch in

Volts position