Herman Miller Mirra Chairs - User Adjustments - Manual (Page 2)

Adjustment Guide 2 HermanMiller Mirra ® Chair
Lumbar Height: Levers on lumbar support
Tilt Limiter: Vertical tab on left front side of seat
Only available on some models.
Only available on some models.
To engage:
Recline and move lever up to define
the limit of recline.
To release:
Lean forward and press lever back.
Engage the tilt limiter when you want to sit in an upright or partially
reclined position.
To adjust:
Rotate levers to loosen, slide lumbar
support up or down to desired height.
Adjust the lumbar height so that it comfortably supports the natural curve
of your spine.
Arm Height: Tab on outside lower base of each arm
Lumbar Depth: Levers on lumbar support
Only available on some models.
To adjust:
Raise tab to unlock arm, raise or lower
arm, lower tab to lock.
For maximum comfort, your arms should make contact with the armpad
without any lift at your shoulders.
To increase:
Rotate levers downward.
To decrease:
Rotate levers upward.
Adjust the lumbar depth so that it comfortably supports the natural curve
of your spine.
Arm Width: Button on inside of each armpad
Arm Angle: Front of each armpad
Only available on some models.
Only available on some models.
To adjust:
Grasp front end of armpad and pivot
inward or outward.
Adjust arm angle inward when using a keyboard; adjust arm angle outward
when using a mouse.
To adjust:
Engage button and adjust arm in or out.
In the proper position, your elbows should be in line with your shoulders.