Pioneer DJM-700-S - Manual (Page 6)

CONNECTIONS
6
En
Always turn off the power switch and disconnect the power plug from its outlet when making or changing connections.
CONNECTING INPUTS
Pioneer DJ CD players
The audio output connectors of a DJ-type CD player can be
connected to the
CD input connectors (channel 1 or 2), or to the
LINE input connectors (channel 1) of the DJM-700-S/DJM-700-K.
Connect the control cord to the CONTROL jack, and set the input
selector switch to [ CD ] or [ LINE ].
Analog turntable
To connect an analog turntable, connect the turntable’s audio
output cable to one of the channel 2 to 4
PHONO input
connectors. Set the corresponding channel’s input selector switch
to [
PHONO ]. The DJM-700-S/DJM-700-K’s PHONO inputs support
MM cartridges.
Connect the ground wire from an analog turntable to the
SIGNAL GND terminal of the DJM-700-S/DJM-700-K.
• Note that no PHONO input connector is provided for channel 1.
Connecting other line level output devices
To use a cassette deck or ordinary CD player, connect its audio
output connectors to one of the DJM-700-S/DJM-700-K’s
LINE
input connectors (channel 1, 3, or 4) or to the CD input connectors
(channel 1 or 2), and set the input selector switch to [ LINE ].
POWER
ON
OFF
BOOTH REC
L
R
L
R
L
R
L
R
L
R
PHONO LINE
CH-4 CH-3 CH-2 CH-1
PHONO LINE PHONO
SIGNAL GND
SEND DIGITAL OUT
(MONO)
CD
R L
LINE
CONTROL CONTROL
CD
1 GND
3 COLD
2 HOT
-6dB -3dB 0dB
MIC 2
RETURN
(MONO) R L
R L
R L
MASTER1
MASTER2
MASTER
ATT.
48k 96k
fs(Hz)
MIDI OUT
Input selector switch
Analog turntable Analog turntable DJ CD player DJ CD player Cassette deck, etc.
CD player, etc.
01_DJM-700_En.book 6 ページ ２００７年７月１０日 火曜日 午後８時４１分