Garmin NavTalk Pilot - Manual (Page 43)

29
Section 3
Basic Phone
Operation
Placing a Call
To place a call:
1. Manually enter the phone number from any page
using the phone keypad and press SEND. The call
timer starts counting after you place the call.
Or...
2. From the PhoneBook Page highlight the name or
number you want dialed and press SEND. The call
timer starts counting after you place the call. Press
PAGE or QUIT to access the PhoneBook Page.
Or...
3. If the number is stored on the Speed Dial Page
simply press the phone keypad number that
corresponds to the phone numbers placed on the
Speed Dial list. Hold the key down for more than
one second to dial that number from any display on
the NavTalk Pilot.
Answering a Call
To answer a call:
1. Press SEND. An incoming call is indicated by a
ringing tone, and the ‘Call—Press SEND’ message
flashing on the display. Once answered, the call
timer starts counting.
If a call is not answered, the ‘Call—Press SEND’
message will continue flashing and the ringing tone will
continue until SEND is pressed. Pressing END will mute
the ringer for this call. When placing a call, wait for the
IN USE icon and the phone call should connect. If a
connection cannot be made, fail tones will sound.
Unsuccessful Call Attempts
If you hear one of the following signals, you have not
successfully completed your call:
• Fast Busy — The cellular system is busy. To
correct, press SEND again after ending the call, to
immediately redial the call, or press END and dial
the number later.
Manual Dialing Page
Call Notification
Cellular Status Display
when redialing a phone
number