HONDA 2009 Odyssey - Manual (Page 444)

Open the tailgate.
Install the rear light assembly in
the rear pillar. Tighten the two
bolts. Snap the bolt covers into
position.
Put the socket back into the light
assembly, and turn it clockwise to
lock it in place.
Test the lights to make sure the
new bulb is working.
Remove the two bolt covers on the
rear pillar by prying on the bottom
edge with a flat-tip screwdriver.
Remove the bolts with a Phillips-
head screwdriver, and remove the
light assembly from the rear pillar.
Push the new bulb straight into
the socket until it bottoms.
Remove the bulb by pulling it
straight out of its socket.
Remove the socket by turning it
one-quarter turn counterclockwise.
Determine which of the two bulbs
is burned out: turn signal or
brake/taillight.
2.
3.
5.
6.
1.
4.
7.
8.
Lights
Replacing Rear Bulbs (in Rear
Pillar)
Ma
int
e
na
nce
441
COVER
BOLTS
BULBS
SOCKETS
2009 Odyssey
Table Of Contents Main Menu