Yamaha EF3000iSE - Manual (Page 18)

– 13 –
AE01083
BATTERY
(See page 30)
Installation
1. Loosen the bolts 1 and remove the cover 2.
2. Loosen the bolts 3 and remove the battery box 4.
3. Remove the band 5 to remove the battery 6.
4. Fill the battery with the electrolyte.
Refer to the instruction sheet included with the
electrolyte for filling instructions.
5. Turn the engine switch to the “STOP” position to
prevent accidental short circuiting.
6. Install the battery onto the battery box.
7. Connect the positive lead 1 to the positive battery
terminal 2, then the negative lead 3 to the nega-
tive battery terminal 4.
NOTE:
9 Clamp the red wire to the positive (+) terminal first,
then the black wire to the negative (-) terminal of
the battery. Do not reverse these positions.
9 For EF3000iSEB, tighten the two positive battery
leads (one from the starter relay and one from the
DC-DC converter) to the same positive terminal
and the two negative battery leads (one from the
engine and one from the DC-DC converter) to the
same negative terminal.
788-006
w
q
q
q
q
788-007
e
e
e
e
r
762-044
t
y
762-045
q
w
e
r
762-045a
to ENGINE
to STARTER RELAY
to DC-DC
CONVERTER
EF3000iSEB
7CH-9-10-a 5/18/04 2:22 PM Page 13