Yamaha HTR-5940 AV - Manual (Page 164)

16
Before using the subwoofer, adjust the subwoofer to obtain the optimum volume and tone balance between the subwoofer
and the main speakers by following the procedures described below.
1
Set the VOLUME control to minimum (0).
2
Turn on the power of all the other components.
3
Make sure that the POWER switch is set to the ON
position, then press the STANDBY/ON button to turn
on the subwoofer.
* The Power indicator lights up in green.
4
Play a source containing low-frequency components
and adjust the amplifier’s volume control to the desired
listening level.
5
Adjust the HIGH CUT control to the position where
the desired response can be obtained.
Normally, set the control to the level a little higher than
the main speaker’s rated minimum reproducible
frequency*.
* The main speaker’s rated minimum reproducible
frequency can be looked up in the speakers’ catalog
or owner’s manual.
6
Increase the volume gradually to adjust the volume
balance between the subwoofer and the main speakers.
Normally, set the control to the level where you can
obtain a little more bass effect than when the
subwoofer is not used. If the desired response cannot
be obtained, adjust the HIGH CUT control and the
VOLUME control again.
7
Set the PHASE switch to the position which gives you
the better bass sound.
Normally, set the switch to the REV (reverse) position.
If the desired response cannot be obtained, set the
switch to the NORM (normal) position.
8
Select “MOVIE” or “MUSIC” according to the played
source.
MOVIE:
When a movie type source is played, the low-
frequency effects are enhanced to allow the listeners
enjoy more powerful sound. (The sound will be thicker
and deeper.)
MUSIC:
When an ordinary music source is played, the
excessive low-frequency components are cut off to
make the sound clearer. (The sound will be lighter and
reproduces the melody line more clearly.)
• Once the volume balance between the subwoofer and
the main speakers is adjusted, you can adjust the
volume of your whole sound system by using the
amplifier’s volume control.
However, if you change the main speakers to others,
you must make this adjustment again.
• For adjusting the VOLUME control, the HIGH CUT
control and the PHASE switch, refer to “Frequency
characteristics” on page 17.
ADJUSTING THE SUBWOOFER BEFORE USE
YST-SW315_215_03.25UB.fm Page 16 Tuesday, April 15, 2003 12:05 PM